gunsite low mount thumb saftey

[napaCCW]

Originally Posted by WKC

I though so. When you installed the GS, you got lucky, .. almost.

I don't recall if this is on the Ultra or TLE. For the Kimber series II, make sure the smith does not set the GS to allow the hammer to fall before the firing pin safety is disengaged. There is a way to see how much margin you have but we'll jump off that bridge when we get to it.

A good smith should be able to take care of it for you.

Its actually both the ultra and the tle. I think I will go back to the stock safeties and have a smith adjust the GS for me. Thanks for the help.